hi,
i hope my english is good enough to answer your question.
when i decided to go with this tire size i build in the llams heightcontroll.
i am sure you know, that you can add in either onroad or offroad mode
3 cm or 5cm +.
i use onroad the + 3 cm mode - without any problems. i tried it also in the regular onroad mode and there were no rubbing at all, but to be honest this was a very good road with no bumps .....( i could find out for you if it is possible to use it without lift onroad.)
i use this lr4 80% on gravel road and offroad. therefore the setting is allways on +3 cm.
i had to do some trimming of the wheelarches -( that was a bad feeling to cut
on a nearly new disovery.)
this lr4 is a diesel so i don't no if the v8 is similar with the exaust or other parts.
at the moment we have a lot of snow - therefor i could'nt test the supension
in rough terrain. but i tried on a steep hill the axle-articulation - then i needed
the full height (offroad and +5 cm ) of the discovery because otherwise in the rear the tire was rubbing heavy. i wanted to have those cooper st maxx,
here in austria you just get them in this size. they are slightly higher than 33 inch.
so - i stop now before it turns out in a book

.....
regards from seefeld in tyrol
adi