Search results
-
2011 5.0 head gaskets
coincidently, the misfire on cylinder three just came back on my engine. i'm going to have it looked at as soon as i can. but, looks like a new remanned engine is in my near future. the K-Seal fix/bandaid lasted 7 months. not bad, i suppose. -
Should I Rebuild?
do you have a link or would i just contact my local dealer? -
2011 LR4 Suspension code U3000-1D
thanks for your help, all. especially, Rover Range. it was a broken wire in the loom that runs near the rear left wheel well. wire is repaired and all is good. black wire with a green stripe. i guess last time i was down at the farm, something got caught up there and tore it. -
2011 LR4 Suspension code U3000-1D
there is surprisingly little info on the web about this code. -
-
2011 LR4 Suspension code U3000-1D
probably helpful to post what U3000-1D means. Control Module-General electrical failure-circuit current out of range (AB). -
2011 LR4 Suspension code U3000-1D
changed out the original Hitachi compressor today with a HD Hitachi style compressor from Lucky8. prior to changing the compressor, i was getting occasional codes stating the compressor was too slow to fill. i thought i had screen shot the code and exact language, but can't find it on my... -
-
PCV Valve Replacement
thanks for the write up. changed both pcv valves this morning in under 20 minutes. -
2011 5.0 head gaskets
so far, so good. no misfires. no hot coolant smell. runs and pulls great. it gets driven everyday around town. we've even taken it out of town to the farm for the weekend. 2.5 hours each way. mix of freeway and county/country roads. just did my first oil change on it since purchase. no... -
OEM vs knockoff gas cap
i picked up a Chinese knockoff and have had no issues. well, other than the restraining strap not friction fitting in the retaining hole (can't think what else to call that right now). -
-
2011 5.0 head gaskets
in your area, what does it cost to do head gaskets on these engines? -
-
2011 5.0 head gaskets
that's what the research i've been doing seems to indicate. so, with that in mind, i poured a bottle of K-Seal Ultimate in the expansion tank. after driving around for a day, the misfires are gone and the check engine light has turned itself off and stayed off for the last week or so. yes, i... -
2011 5.0 head gaskets
dropped the LR4 off at the mechanic's to diagnose the misfire codes. looks like there is coolant leaking into cylinders 3 and 4 per the borescope. is it worth it to have the head gaskets redone or is a used engine the better bet? prior to my buying the LR4 the head gaskets had been done by a... -
Different oil level readings with hood open
you're right. i didn't need to do it. i just did it to see if there was a difference in readings based on methods. per my previous post, i did the oil level reading per the owner's manual. then i turned the LR4 off, then back to the on mode (Start button pushed, no brake pedal... -
Different oil level readings with hood open
2011 LR4 5.0 Rover sat on level ground for at least half an hour after driving. went out and checked the oil per the manual. read exactly at the halfway mark. then checked it via the bypass method. showed 0.5 quart low. i have not yet had the opportunity to run the test again. -
96 Disco Problems (w/fault codes)
www.troublecodes.net/landrvr/ here's a link. all the codes you listed are misfire codes. definitely change out the plugs and wires. -
96 Disco Problems (w/fault codes)
your mechanic's advise is a good place to start. try some kingsborne 8mm wires and the cheap champion plugs. i wouldn't use the OE 7mm wires. when i went with those my fuel mileage actually dropped. i couldn't find the link i used to have to the obd2 codes or else i would have... -
I really want a Disco but...
2004 is considered one of the best years for the Discovery. also the last year for the D2 model. -
Disco 1 radio replacement
i'm in the same boat. my radio fades in and out randomly. i tried tightening up the connections at the amp, but no luck. so, come on with the suggestions. -
SES No Power, Fuel Filter and Door locks
Mike is right. Get the codes read. The flashing SES I can often mean misfires. This may be something as simple as new plugs and wires. I think most local autoparts stores will read the codes for free. Write down what codes come up and then get back to the forum. -
Cheap Way to Replace New Style 02's
yeah. sorry. that occurred to me right after i hit the send button. nothing like wasted bandwidth.
