Search results
-
Fuel Outlet Flange Recall and Other Services
They can't be serious. Parts required for the recall. Fuel tank flange assembly LR112785 1 Fuel filter LR175172 1 Bracket LR113338 1 Fuel tank flange O-ring LR117476 1 Hose clip CN1005 New fuel filter:- Rover Range
- Post #5
- Forum: LR4
-
Fuel Outlet Flange Recall and Other Services
If you're doing the fuel pump, replace the fuel senders too.- Rover Range
- Post #3
- Forum: LR4
-
Fuel Outlet Flange Recall and Other Services
A new fuel filter is part of the recall!- Rover Range
- Post #2
- Forum: LR4
-
Water leaking just started yesterday, HELP
Check the sun roof drains in the passenger foot well.- Rover Range
- Post #2
- Forum: LR4
-
Transmission “Free Wheeling”
I would disconnect the battery for 15 minutes. That will clear the transmission learned adaptations. See if that helps.- Rover Range
- Post #2
- Forum: LR4
-
Discovery 4 sdv6 GS Dreaded suspension fault help needed
What DTCs do you have? Throwing parts at it will cost you way more than a proper diagnosis.- Rover Range
- Post #2
- Forum: Discovery
-
2020 Range Rover Sport Hse - Crank but no Start, after accident , fuel pump not working
The restraints module (SRS) has locked out the fuel pump. The module will need to be replaced with a new one and reflashed .- Rover Range
- Post #2
- Forum: Range Rover
-
-
Water Pump & Outlet Pipes Replacement
Supercharger doesn't have to be removed to replace the front crossover pipes.- Rover Range
- Post #7
- Forum: LR4
-
Open to Suggestions
Better hope the new sensors are good. :rolleyes:- Rover Range
- Post #48
- Forum: LR4
-
Passing Wires from the Engine Bay through the Firewall to the Cabin
Follow the hood release cable where it goes through the firewall. Use that grommet to route your wires.- Rover Range
- Post #2
- Forum: Range Rover
-
Zip kit and fluid change, now won't go past 5th
Either low on fluid or the shuttle valve at the manual linkage not in the proper position.- Rover Range
- Post #5
- Forum: LR4
-
Open to Suggestions
Some vehicles have a symposer. Which is attached to that fitting. The vehicles that don't have it, the port is capped off. The symposer creates a V8 like sound on acceleration.- Rover Range
- Post #32
- Forum: LR4
-
Mysterious Rear Thump Clump
Have the dealership diagnose it. I'm sure they have heard the noise before. Guessing can get expensive.- Rover Range
- Post #4
- Forum: Discovery 5
-
Persistent P0430 on my 2012 5.0
Only the one. The only sensor that monitors the cat efficiency is the very last one.- Rover Range
- Post #8
- Forum: LR4
-
Persistent P0430 on my 2012 5.0
A bad sensor won't cause that DTC. Convertor needs to be replaced. Or, get one of these. They do work...- Rover Range
- Post #5
- Forum: LR4
-
Check engine light on
The factory tool is much better. The DTCs you listed would trigger a different warning light.- Rover Range
- Post #14
- Forum: LR4
-
Check engine light on
GAP tool may be sending you on a wild goose chase.- Rover Range
- Post #12
- Forum: LR4
-
-
No start / no dash display after battery replacement
Can you hold the key fob under the steering column and cycle the key on?- Rover Range
- Post #4
- Forum: Discovery
-
No start / no dash display after battery replacement
Try disconnecting and reconnecting the battery. Check the battery ground cable at the body ground. Telematics module could be causing your issues.- Rover Range
- Post #2
- Forum: Discovery
-
Transmission Heat Shield
On the L405 and L494 models. There is a bulletin to remove completely, the bracket and heat shields. Those models, there is a lot less framing around the transmission.- Rover Range
- Post #4
- Forum: LR4
-
Valve cover gasket replacement ($3,200)
Nothing breaks when doing valve covers. $3,200 seems excessive. The job pays 8hrs. Plus seals.- Rover Range
- Post #2
- Forum: LR4
-
Transmission Heat Shield
Bracket needs to be replaced with this part # LR073535 And foam pads installed on bracket. Part # LR044464- Rover Range
- Post #2
- Forum: LR4
-
Open to Suggestions
You can put the hood in service mode for more room. Disconnect the hood struts and flip the hood vertical. Then flip the locking tabs into place.- Rover Range
- Post #20
- Forum: LR4
