Recent content by xray132
-
The obligatory "Show off your LR3' thread
hogback This one. Guy at the top didn’t think I would make it. Cycle that came up behind me crashed. -
The obligatory "Show off your LR3' thread
Browns Camp Funny you mention TSF .You been on this one, Cedar Tree loop? I Thought their new trail felt like Cedar Tree, tight twisty and know where your corners are or you might scar a stump or rock but not difficult. TSF has far more trails of different degrees of difficulty and some I... -
The obligatory "Show off your LR3' thread
Yacolt Burn /Larch Mountain/Jones Creek Area These are the first trails of a ten year development plan including a campground. It's new so, not much of a challenge but wait for a little rain to develop them. They did throw a few big rocks in the trail to hear my sliders and skid plate talking... -
The obligatory "Show off your LR3' thread
Weekend wheelin 4 year old off road warrior on the Yacolt Burn, outside Vancouver WA A lot of thanks to Pistons Wild Motorsports Club and many others for cutting through the red tape and opening up 8 miles of our first 4 wheeling trails. -
Help Towing a 23' Airstream Travel Trailer
It will work Here's my eaz lift set up, it was the set up I was already using. Sway bar is critical for the short wheel base. Just take your time except at the bottom of a hill, then get on the throttle if you can to keep your rpm up. My Super Duty and my Grand Cherokee Ecodiesel both heat up... -
Hand Winch for Self Recovery?
Like my ARB Magnum I carry an ARB magnum. 5300lbs pulling, 3500lbs lifting capacity. I like the 65ft of 11mm wire winch rope to extend my electric winch instead of dragging my synthetic line on the rocks. I have a friend with a Wyeth-Scott and it is a quality piece. Did the hi lift thing once... -
2005 lr3 285/60 r18 rubbing frame! help!!
You can leave them off for now. You cut an inch off the front with a 4 1/2 grinder with a cut off wheel. Have anyone with a welder weld the flat part back on. They say they stop the tire from coming up in your floor on a head on. I still have mine on the floor in the garage, but I have RS... -
The obligatory "Show off your LR3' thread
I believe that is. It was the last trail before heading to Sand Lake at the coast and my son in law destroyed the spyder gears in his 9” posi on his early bronco right there in that hole. Others pics are random during the day. It makes me respect how bad the hill is getting and I appreciate how... -
The obligatory "Show off your LR3' thread
Last family outing Tillamook State Forest, Oregon Just a couple of pics one of the kids took of the rover playing on our recent family outing. -
Cooper Zeon LTZ on LR3 - cracking sidewalls
here's mine They were quiet, surprisingly good traction, and I got 45K on them. This one split out below the tread on the sidewall -
The obligatory "Show off your LR3' thread
That is a no roof rack zone and that is locked down low. The hairy part is that big rock that my driver’s tire is against pushes you sideways toward the stump. I was worried about passenger side windows. -
The obligatory "Show off your LR3' thread
13 (cedar tree) is slow and tight. You see plenty of trees missing bark. I would guess too many vehicles wider than a LR3. If you don’t know where your bumper corners and sides are, you will by the end of that trail or you’ll add to the tree misery. We did trails 4 Powerline, 10 and 13 Cedar... -
The obligatory "Show off your LR3' thread
Last week Browns Camp OR It's hard to remember to take pics when your having a blast. Here's last week. -
Do you carry a weapon in your truck?
I'll share the Trunk Monkey Carrying a Glock 27 in a Cross Breed Holster. "Trunk Monkey" Keltec Sub 2000 uses 25 round Glock 40 S&W magazines. If the Monkey has any problems going through the 125 rounds. Just continue with your Gock 27 with the big mags. Folds nicely camo'ed in my First Aid Bag -
Off-roading wound
Place dynamat on top of your RS slider under the compressor area before you mount them up. It stops the noise from resonating back off the steel plate. I have it on my LR3 and I think it is as quiet as it was before the sliders.
