Search results
-
U
C1130-66 Air Spring Supply
usually if LR is left in TTM, you will get a message on the dash info center saying something like "vehicle not in customer mode" -
U
2010 LR4 Air suspension need advice
indicative off a small leak in the front circuit. As per above instructions, pull the EAS fuse and let sit overnight. If both fronts drop, suspect the front block. if one side only drops suspect the strut on that side or possible voss connections. at that point, soapy water on all connections... -
U
Replacing Lower Control Arms 2016 LR4 HD
THe Meyle HD LCAs are good as are the LR branded or Lemforder [LR susppier]. Last ones i used were the Meyle HDs...have about 30k miles on them..very good. As others stated, set the system in "tight tolerance mode" prior to alignment. back to customer mode immediatley afterwards. i see you are... -
U
2015 LR4 Coolant Issue - Nothingburger or...
if it empties the overflow tank, you have a leak somewhere. It may be small but if it is one of the crossovers, it can become big almost instantaneously and ruin your engine in short order. you didnt say how many miles are on the Disco or i the crossovers have been replaced before but if it has... -
U
Rusted brake line
ours had a similar issue two years ago..in the shop for a new epb module and the mechanic happend to bump the brake line, it started leaking...was nearly rusted through [what gives with this? brake lines should be coated] anhow, yes entire exhaust has to come off, skid pans off, r&r lines and... -
U
How-to DIY: Upgrade to new style fuel tank flange & filter
definately a coincidence. i you pulled away quickly on a cold engine, especially with some timing chain slack, the oil pressure in the tensioners had not had time to pressurize the tensioner and "tighten" the chain thus giving the cam timing error. I would listen carefully for a while for timing... -
U
2012 LR4 - Diagnosing two separate vibrations
i would also carefully inspect the front lower control arm bushings. before i replace our LCAs, they would give a vibration/shutter similar to warped brake rotors. -
U
mysterious clunk/knock after closing driver's door
yeah i dont think it was eminating from the mirror. i guess it could have been something in the door pocket but he has car on the way back to school today so i guess i will wait and see...thanks -
U
mysterious clunk/knock after closing driver's door
Hi All, this is certainly minor compared to what seems to crop up with LR4s but i noticed recently when i close the door i then hear a quick Knock from the door [i am massuming it is coming from the lock when car is scuring itself]. anyone else ever had this happen. My son typically drives the... -
U
New Tires to replace Cooper Zeon
count me in as another vote for the michelin cross climates. fantastic. had LTX premiers on it prior and they rode nicely but wore out in less than 15k miles. The cross climates are great on the highway and really good in rain, snow, ice etc... -
U
2012 LR4 coolant leak
as mentioned earlier, it is a dis service if your mechanic does not replace the crossover pipes and rear heat manifold while in there unless they have been replaced very recently already -
U
2012 LR4 coolant leak
Sorry for your loss, Cindy. I would surmise that the intake manifold gaskets are just routine replacement since the intake has to be removed to change out the oil cooler. [probably a good idea but not absolutely necessary if originals are in good shape but cost will be insignificant in the... -
U
2012 LR4 coolant leak
those codes are really not connected to coolant leaks and overheating. likely you have cracked or leaking coolant crossover tubes [front] and/or rear heat manifold leaks. both are plastic and if they have not been replaced prior, at 13 yrs old and 70k miles are shot. If coolant is allowed to get... -
U
Maf Sensors...
It is securely attached. i cleaned them both several times with MAF cleaner. Replaced both air filters with oe Land rover paper filters. Did clean out a few dirt dauber nests in the housings...it did not set cel for a couple of thousand miles but now triggered it again as p0101. -
U
Maf Sensors...
Thanksk, i like bosch stuff; usually reliable. Seems to me that Denso is the oem for these. I will probably give the bosch a try -
U
Control Arms
You might consisderr the Meyle HD LCAs. I put them on ours a year and half ago. They are solid, bushings supposed to last longer than LR, and the ride is great [no harshness etc.]. I think they were about $200 or so apeice. -
U
2016 LR4 Original Owner. 75k. Thinking about selling, but not sure of alternative rides that can do everything this does.
haha...just purchased a 63 Chev C-10. It is as basic as the LR is loaded. -
U
Maf Sensors...
son advised me CEL illuminated and tripped p0101 again after several months of not doing it. Have cleaned the MAF sensors twice and replaced the air filters. checked the wiring etc. so guess i will drop the $$ for some new maf sensors. I see LR, Denso [i think oem LR], Bosch and a myriad of el... -
U
2016 LR4 Original Owner. 75k. Thinking about selling, but not sure of alternative rides that can do everything this does.
Drove a 2022 Discovery p360 HSE...ingenium 6. It was a nice ride; lots of power, quiet, towing capacity same as LR4. Comfort was excellent and I actually like the styling [many others dont] but i thiink they are sales dogs so may not be around too much longer. -
U
Cooling System Replacement - Dealership.
I did this on my sons lr4 V8 back in the spring. LR oem front crossover pipes about $125, rear heat manifold about $150, LR waterpump about $300, LR thermostat and housing about $75 plus a few odds and ends and 1 gal of LR coolant--total parts about $700. Took me about 6-7 hours then a leisurly... -
U
Best windshield replacement option?
Safelite replaced our LR4 heeated windscreen last year. the screen is Pilkington branded. -
U
OEM vs knockoff gas cap
our oem leash broke a year or so ago but cap was fine. i ordered a chinesium tether and installed it on the oem cap. works ok but the tether button is a loose fit in the retaining hold. I might put a dab of glue in there at some point
