Question to those , who already have Kaymar or TR bumper installed.
Last SAT. I needed to clean, prime and re paint area where tow eye and electrics are, as it really rusted underneath plastic tow hook cover. For obvious reasons, I wanted to gain a good access to it , so I figured , I will take off entire plastic bumper just to make sure I did not missed a spot in the immediate vicinity.
Although, I own LR3, I believe mounting points should be the same on LR4 ?
Rear lights off,four screws underneath off, four very hard to get to rivets off,and two hex screws on each side, by rear lights.Here is , where my problem appeared...Are these two hex mounting points are used for Kaymar or TR steel bumper or they are attached differently?
The reason I asked is because My right hex screw is just turning around and I am unable to tighten it nor take it out.There must be some kind of threaded part inside the steel quarter panel, that is loose and it probably turns around with bolt inside.
If I go for one of these steel bumpers, I wonder if I have to cut or drill the bolt out, in order to take the plastic one off,but the big Q is , if it will have to be re use in same way for a steel one?