Recent content by morseman2003
-
M
If you ever thought about replacing your side door molding...
Here's a photo which shows a hazy white mark running parallel with and above the crease at the bottom of the door. It's not very clear but if you zoom in you can just make it out. To be honest, it just looks like a dirty mark and I've learnt to live with it (ignore it!) but it was annoying when...- morseman2003
- Post #7
- Forum: LR3
-
M
If you ever thought about replacing your side door molding...
I'll try and get some photos up ASP but I'm away for a few days later this week but will try and take them before I go. Regards Trevor- morseman2003
- Post #6
- Forum: LR3
-
M
If you ever thought about replacing your side door molding...
I did the same with mine but used a low level heat gun to loosen the adhesive. Left with a mark in the paint which I'm sure was where I ended up pulling too ******* the old molding and so stressed the paint... I've polished a few times and it doesn't look too bad but decided it wasn't worth...- morseman2003
- Post #2
- Forum: LR3
-
M
iPad Mount/Support in LR4 for use while driving/off roading
I use a similar mount from http://www.ram-mount.co.uk which works well and doesn't suffer from too much vibration. Regards Trevor- morseman2003
- Post #4
- Forum: LR4
-
M
HDC Fault, Transmission Fault, Special Programs Not Available - My Exprience
Hi I've been suffering the same problem recently on my 2007 D3. I read the various threads and took the option to replace the brake switch and while I was at it, also swapped out all the brake lights for Land Rover supplied parts. That was two days ago and I have suffered the same problem both...- morseman2003
- Post #24
- Forum: LR3
-
M
Greetings from the UK
Greetings from the UK, I have recently purchased a 2007 Discovery 3 which is fairly standard except AT tyres. Looking forward to opportunities to get off road and enjoy the fun elements of driving such a capable vehicle...:hello::hello::hello:- morseman2003
- Thread
- Replies: 3
- Forum: Introduction
