Transmission Heat Shield
- Thread starter timc930
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Rover Range
Full Access Member
Bracket needs to be replaced with this part # LR073535
And foam pads installed on bracket. Part # LR044464
And foam pads installed on bracket. Part # LR044464
Thanks. Ordered bracket yesterday, found one on eBay, cheap compared to LR. Figured I'd replace with eBay (dlzautoparts) bracket while I have the broken one welded. Was not aware of the foam, as foam was not on bracket.
I was curious about removing, as I thought LR did not put this bracket/shield on the earlier LR4's, maybe because of the plastic trans pan used on the 14-16?
Rover Range
Full Access Member
On the L405 and L494 models. There is a bulletin to remove completely, the bracket and heat shields.
Those models, there is a lot less framing around the transmission.
Those models, there is a lot less framing around the transmission.
I just bought a 2016 L405, read the bulletin, I'll remove if/when it cracks and rattles like my LR4 did....unless removal allows for better airflow for cooling????
Last edited:
Check the Bulletin, I believe it addresses your concern...as it discusses retaining bolts for cable routing
Last edited:
I just googled “Range Rover Heatshield TSB” …
Similar threads
