Recent content by cj60
-
Thermostat housing torque specs
Thank you and it helps. Sent from my iPhone using Tapatalk -
Thermostat housing torque specs
I will be replacing the thermostat housing anyone here have the torque specs to share... Thank you. Sent from my iPhone using Tapatalk -
2006 Range Rover hse smog problem
Drive Cycle ? Search or google it. Sent from my iPhone using Tapatalk -
Suspension Problem, I haven't one! LR3
O-ring repair kit covers all 3 valve. I will work on the valves this weekend and I can give you an update. -
Suspension Problem, I haven't one! LR3
I have a similar situation here, suspension fault was lit in red last night. I already have the Valve block O-ring repair kit for front rear and relief valve and hopefully it’s not that hard. I did repair the compressor pump last year. Sent from my iPhone using Tapatalk -
Another Suspension Fault - with pattern
rebuild kit works for me with the exception of the bracket top bolt (pita). Sent from my iPhone using Tapatalk -
rear wiper motor successfully fixed
They also have this on eBay item# 111978716030 http://www.ebay.com/itm/Rear-Window-Wiper-Motor-Repair-Gear-For-Range-Rover-Land-Rover-Freelander-/111978716030?hash=item1a12739b7e:g:sy4AAOSws8ZXHbhq&vxp=mtr and its $4.00 cheaper on shipping. -
rear wiper motor successfully fixed
I didn't see any Land Rover part # on it. If you go to Amazon and search for "Bross BGE24" you'll see it. -
rear wiper motor successfully fixed
Here it is : yes, a groove in the middle of the teeth about 1.5 inch -
rear wiper motor successfully fixed
I have been searching for this a while, until I found this replacement gear which is common for failure. If you have a noisy rear wiper and doesn't make a full sweep, this maybe your solution. I took a chance and order this without looking inside the motor if this part is the same. Black gear... -
plastic isolation pad on intake manifold ?
is this supposed to be here? I have no idea. Is there a plastic isolation pad on the engine ? -
-
Replaced Expansion Tank and still Low Coolant Level
looks like a bad one ... Sent from my iPhone using Tapatalk -
Replaced Expansion Tank and still Low Coolant Level
I tried your suggestion and still the same, looks like the floater stays in the bottom. Sent from my iPhone using Tapatalk
