Hi all, I have a 98 Disco 4.0 that I bought recently. When I use my ScanTool it doesn't seem to throw any codes and it shows that the MIL lamp is "off". I replaced the MAF sensor and in the "dashboard" it shows that it is not functioning. Any ideas?
98 Disco not throwing codes and new MAF sensor isn't getting signal
- Thread starter johnt1963
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Disco Mike
Full Access Member
- Joined
- Jun 20, 2009
- Posts
- 1,949
- Reaction score
- 4
Cracked circuit board or corosion.
Last edited:
No Codes
Thanks Mike ( I think
), Everything else (on the ECU) seem to be working. I checked the wiring from the MAF back to the ECU and it's good. The MAF is working and the engine starts but won't idle. When I pull the MAF and start the engine it's the same as if it were still there. So, that must be part of it. If I get another ECU will it have to be "flashed" or just mated to my vehicle?
Thanks Mike ( I think
), Everything else (on the ECU) seem to be working. I checked the wiring from the MAF back to the ECU and it's good. The MAF is working and the engine starts but won't idle. When I pull the MAF and start the engine it's the same as if it were still there. So, that must be part of it. If I get another ECU will it have to be "flashed" or just mated to my vehicle?
