I finally got around to start rattle canning my wheels this week. I did a test first on one of the spares I got from goinsurfin. I must say it turned out pretty good.
To prep (this is what I did and I'm not saying this is the best way):
1. Cleaned as best I could.
2. Roughed up and removed rough spots with steel wool.
3. Went over surface with 600 grit sand paper.
4. Blew off with compressed air.
5. Cleaned with brake cleaner and microfiber rag.
6. Taped off between lip of rim and tire, and also covered inner hub part about 1/2" down.
7. Spray away, both back and front. 3 lighter coats. I also am spraying the entire center cap. My logos are faded.
I just used the Rustoleum paint and primer SATIN black. I have two more of my wheels to go and hope to finish up this weekend. I waited at least two days before mounting and will post pics early this week once all are done and on!
To prep (this is what I did and I'm not saying this is the best way):
1. Cleaned as best I could.
2. Roughed up and removed rough spots with steel wool.
3. Went over surface with 600 grit sand paper.
4. Blew off with compressed air.
5. Cleaned with brake cleaner and microfiber rag.
6. Taped off between lip of rim and tire, and also covered inner hub part about 1/2" down.
7. Spray away, both back and front. 3 lighter coats. I also am spraying the entire center cap. My logos are faded.
I just used the Rustoleum paint and primer SATIN black. I have two more of my wheels to go and hope to finish up this weekend. I waited at least two days before mounting and will post pics early this week once all are done and on!
Attachments
Last edited:
